Wood Finishes - Exterior - Anti - slip (1 products found)

PRODUCT DESCRIPTION
Clear wood finish for wooden flooring in indoor areas
for which a higher slip resistance is required. Osmo
Polyx®-Oil Anti-Slip uniquely combines the advantages
of natural oils and waxes in one product. It is
stain-resistant, water-repellent and abrasion-resistant.
In comparison to conventional finishes, the use of
plant ingredients creates a more even colour and
more harmonious appearance. Simple application –
without primer or intermediate sanding – this saves
time and money. Suitable for wood; microporous surface
will not crack, peel, flake or blister. Resistant to
wine, beer, cola, coffee, tea, fruit juice, milk and water
acc. German DIN 68861-1A – no water spots.The dry
finish is safe for humans, animals and plants (resistant
to saliva and perspiration acc. German DIN 53160,
suitable for children‘s toys acc. EN 71.3).
RECOMMENDED USE
Osmo Polyx®-Oil Anti-Slip is ideal for the protection
of all wooden floors for which higher slip resistance
is required (commercial/public interiors), such as solid
wood, plank, strip, OSB and cork flooring.
INGREDIENTS
Based on natural plant oils and waxes (sunflower oil,
soya oil, thistle oil, carnauba wax and candelilla wax),
paraffin, siccatives (drying agents) and water-repellent
and non-slip additives. Dearomatized white spirit
(benzene-free). EU limit value for this product (cat. A/i):
500 g/l VOC (2010). This product contains max. 500
g/l VOC. Detailed declaration of ingredients available
upon request.
STORAGE
Up to 5 years and longer if can is kept dry and closed
tightly. If thickened by frost, store for 24-36 hours at
room temperature before use.
SURFACE PREPARATION
Wood surface must be clean, dry and frost-free (moisture
content max. 18%).
Osmo Polyx®-Oil Anti-Slip is ready to use. Do not thin.
Stir well before use.
Clean old microporous stains thoroughly. Old paints
and lacquers must be completely removed. As a general
rule, wear a dust mask during sanding works. Fill
small cracks, larger joints or holes in wood (with Osmo
Wood Filler).
Sand wood surfaces carefully. Begin with coarse
sandpaper – final sanding work for flooring P120-150.
Before oiling the surface, remove sanding dust with a
broom or vacuum cleaner.
The finished surface is influenced by several factors,
including the condition of the wood. Therefore, a trial
application is always required, especially for unfamiliar
surfaces.
METHODS OF APPLICATION
With Osmo Flat Brush, Floor Brush or Microfibre
Roller, apply thinly along the wood grain and spread
well.
Allow to dry for approx. 8-10 hours under good ventilation.
After drying, quickly apply a second coat also thinly.
For renovation works on previously oiled surfaces, one
coat applied to the clean and dry surface is usually
sufficient.
Note: Osmo Polyx®-Oil Anti-Slip cannot be evened out
with a single disc machine.
POLYX®-OIL ANTI-SLIP/
ANTI-SLIP EXTRA
Ideal for wooden flooring for which
higher slip resistance is required.
TECHNICAL DATA
Specific gravity: 0.88-0.91 g/cm³
Viscosity: thixotropic, viscous/creamy
Odour: faint/mild, after drying odourless
Flash point: >60°C acc. DIN 53213
1COAT
24 m²/ 1l
Anti-

See all: Wood Finishes > Exterior

You are on page 1 of 1

Photo of Osmo Anti Slip Decking Oil
Osmo - Osmo Anti Slip Decking Oil

Our Price from:£18.91